Ausom DT2 PRO 52V - 58.8V 2A Charger

Ausom DT2 Pro Standard Charger – 52V (58.8V – 2A) – Active Cooling

This 2A standard charger for the Ausom DT2 Pro delivers a 58.8V output. It is designed for the original 52V (14S) lithium-ion battery configurations detailed below.

It uses the original red 3-pin Ausom connector shown in the photos, allowing it to plug directly into the corresponding charging port on your electric scooter.

Its 2A current is suitable for standard charging and serves as a replacement solution or an additional charger to keep at another charging location.

This charger is equipped with active cooling to promote efficient heat dissipation during long charging sessions. This version features a plastic housing.

Technical specifications

• Output voltage: 58.8V DC.
• Charging current: 2A.
• Battery type: 52V (14S) lithium-ion.
• Connector: original red 3-pin Ausom connector.
• Housing: plastic.
• Cooling: Active Cooling.
• Estimated charging time for Ausom DT2 Pro (23.4 Ah): ≈ 11.5 hours.
• Weight: 0.4 kg.
• Integrated protections: overvoltage, overcurrent, overheating, and short-circuit.
• LED indicator: red = charging / green = charge complete.
• Included: Source’IT charger and power cord.

A charger adapted for the Ausom DT2 Pro

The Ausom DT2 Pro uses a 52V 23.4 Ah lithium-ion battery. Its large capacity is suitable for long rides but requires more charging time with a standard 2A current. The 4A and 5A versions allow for faster recovery of range between trips.

• Ausom DT2 Pro: 52V 23.4 Ah (1216.8 Wh) lithium-ion battery.

The 52V nominal voltage refers to the battery; the 58.8V voltage corresponds to its maximum charging voltage. The choice of charger also depends on the connector and its wiring. This listing targets the original configurations listed, with the pictured connector.

The advantages of this 2A version

• Output regulated at 58.8V for the corresponding 52V configuration.
• Original red 3-pin Ausom connector visible in the photos.
• Standard charging to replace your charger or have an additional unit.
• Active cooling to vent internal heat.
• Plastic housing and integrated electronic protections.
• 2-year warranty and Source’IT technical support.

Comparing Ausom DT2 Pro chargers

Versions in this family deliver the same final voltage of 58.8V. The charging current, housing, and estimated duration distinguish the products. The 2A is suitable for standard charging, the 4A for fast charging, and the 5A for shorter charging.

Ausom DT2 Pro – 23.4 Ah

• 2A standard: ≈ 11.5 hours
• 4A fast: ≈ 5.75 hours
• 5A ultra-fast: ≈ 4.5 hours

These durations are estimates for a 0 to 100% charge with a single charger, calculated by dividing the battery capacity in Ah by the charging current in A, then rounding down to the nearest quarter hour. The starting level, temperature, and battery condition will cause the actual time to vary.

• Ausom DT2 Pro Standard Charger 52V – 58.8V 2A
• Ausom DT2 Pro Fast Charger 52V – 58.8V 4A
• Ausom DT2 Pro Ultra-Fast Charger 52V – 58.8V 5A

Find all Ausom DT2 Pro chargers to compare versions and check their photos.

Safety and reliability

Regulation at 58.8V and electronic protections accompany the charging of the corresponding 52V battery. Active cooling cools the charger; it does not directly cool the battery. Leave the openings unobstructed and allow a hot battery to cool down after use.

FAQ – Ausom DT2 Pro 2A Charger

Is this charger suitable for my scooter?

It corresponds to the models and batteries listed in the compatibility section, with the pictured original red 3-pin Ausom connector. Check the exact model, voltage, and plug of your version before choosing.

How long does charging take?

Ausom DT2 Pro 23.4 Ah: approximately 11.5 hours with this 2A charger. A partially charged battery will take less time.

Does the charger have a fan?

Yes. This 2A version has active cooling and a plastic housing. The fan may be audible during charging.

Can I keep it as a second charger?

Yes, to have a charger at another location. The simultaneous use of two chargers depends on the ports and the total current accepted by the scooter version; it cannot be assumed simply by the presence of two sockets.

What is the difference from other power ratings?

The 2A is the standard version of this family. The list and links above allow you to compare other versions for your exact battery capacity.

Warranty, shipping, and support

• 2-year warranty on the Source’IT charger.
• Shipping within 24/48 hours from France.

Need a compatibility check? Email contact@source-it.fr with the exact model, a photo of the charging port, and the battery information.

Photos are not contractual – Source’IT.